Post by cr8n on Apr 10, 2016 13:35:23 GMT -7
This turns out to be very simple, but there isn't much info on it on the net.
1st. Save your CAD drawing as dxf. I USED 95 version.
Then open Corellaser and select "import"
To navigate to your dxf.
Finally, open the cut options icon on the top right, set your speed, and add the task. ...that's it.
FWIW. I did have to set my corel settings to wmf for both cutting and engraving to make the laser stop cutting multiple passes on each line.
1st. Save your CAD drawing as dxf. I USED 95 version.
Then open Corellaser and select "import"
To navigate to your dxf.
Finally, open the cut options icon on the top right, set your speed, and add the task. ...that's it.
FWIW. I did have to set my corel settings to wmf for both cutting and engraving to make the laser stop cutting multiple passes on each line.