Post by turbohawk94 on Jun 6, 2019 20:31:27 GMT -7
I got a new computer and loaded new software for the K40 (LaserDRW3) basic software. When job finishes for one product, on old computer it would go back to starting position, hit spacebar and enter and it would engrave next product. Well on new computer, after engraving first product, hit spacebar, it goes all the way back to origin when I turned on machine basically resetting then returning to start position but then begins engraving. If the product is off a little it then cuts wrong or off not allowing me to set to desired area. I copied configuration file from old computer to new but it still does same thing. I do have the do not back checked. This was a problem when I purchased laser years ago but one day it just started going back to start point on cut, not all the way back to origin and back. Out of the blue it just started working. If you have any ideas it would be greatly appreciated.