|
|
Post by Coherent on Dec 3, 2015 15:16:56 GMT -7
A simple aztec design engraved on a piece of 1/4" birch with a 40w K40. 140mm speed at about 3 power.  |
|
|
|
Post by wire10ga on Dec 5, 2015 7:00:05 GMT -7
Looks good.
|
|
DIY3DTech.com
New Laser Tech
Specializing in promoting DIY small scale fabrication technology...
Posts: 4
|
Post by DIY3DTech.com on Dec 8, 2015 5:32:51 GMT -7
Nice, how did you cut it out?
|
|
|
|
Post by Coherent on Dec 9, 2015 9:46:15 GMT -7
I attempted initially to cut it out using the laser, but realized pretty quick it would take a number of passes, so just used the bandsaw and cleaned it up on a stationary disk sander. I imagine it could have cut it with the laser, but would have taken a bit and burnt the edges more. If nothing else the laser draws a perfect line for cutting & sanding lines!
|
|
