|
Post by mikesds on Apr 30, 2017 17:48:46 GMT -7
Hi1 can any body identify this control board. I is a Lihuiyu Studio Labs HT-Master-5 but does not appear in any photos or data to say whether it is an M5-6 r other code in coral laser setup software? Any help would be appreciated as set up as M5 it only soft engraves and cuts and it takes about 6 tries to get a decent engrave and I gave up after 8 tries at cutting and still did not cut through the sheet of 2mm card 1
Regards Mike
|
|
flyoz
New Laser Tech
Posts: 2
|
Post by flyoz on Mar 5, 2018 0:08:37 GMT -7
Hi Mike I am a rank newbie but this may help Can you look at the actual controller board? it should have the info you want printed in white lettering on the green pheolic circuit board For example I found my k40 Controller board had this information printed Just under the USB connector on the board (With my eyes I had to remove the board and read the tiny lettering with a magnifying glasss ) It had printed: Lihuiyu Studio Labs design for Laser Machines Hangzhou firmware revision 2016:01:01 6C6879 Laser M2:9 (this is what you will look for on your machine it maybe a similar number then M5 etc) On a paper sticker on one end is these 2 numbers 75FFB2F5 82436957 Hope this helps Bill
|
|